When it completes this process you will see a Conclusion Screen. The Assistant will 'pair' the mouse with a Passkey. Once the mouse appears in the list, Click CONTINUE.ĩ. (NOTE: Pressing and Holding the Connect/Rest button will make the mouse 'discoverable'). You will want to press and hold this button until the mouse appears in the list. Locate the CONNECT or RESET button on the bottom of the mouse. The Bluetooth Setup Assistant will begin to search for the mouse. Select the 'Mouse' option in the 'Select Device Type' window and click CONTINUE.Ĩ. Click CONTINUE through the Introduction Screen.ħ. The Bluetooth Setup Assistant will open.Ħ. This button should be located at the bottom, right hand corner of the window. Now click the "Devices" tab next to the 'Settings' tab and locate the SET UP NEW DEVICE button. In the Bluetooth Preferences window, click the Settings tab and select the TURN BLUETOOTH ON button if the Bluetooth Power status reads "off."ĥ. Open the System Preferences and Click "Bluetooth" under the Hardware pane.Ĥ. If the mouse has an ON/OFF switch on the bottom of the mouse, make sure the switch is set to the 'ON' position.ģ. Allow the mouse to charge for at least five minutes before continuing with the setup.Ģ. If the batteries are built in, plug the charger's AC adapter into an AC power source and place the mouse in the charger. If the mouse requires batteries, install them now. Follow the steps below to set up a Bluetooth mouse on the Mac OS 10.4.x:ġ. No Logitech software is required to use a Bluetooth Cordless Mouse with OS X as the mouse will use the Mac's built in Bluetooth and default mouse drivers. Note: If you have a Logitech Bluetooth Device other than the V270 Cordless Optical Mouse, please refer to Knowledge Base article 5257. The information applies to the following operating systems: V270 Cordless Optical Mouse for Bluetooth The information in this article applies to the following products:
0 kommentar(er)
